Sleeper
From Unofficial Stationeers Wiki
 | |
| Recipe | |
|---|---|
| Created With | Fabricator |
| Cost | 10g Iron, 2g Gold, 3g Copper |
| Operation | |
|---|---|
| Power Usage | 100W |
| Construction | |
| Placed with | Kit (Sleeper) |
| Placed on | Small Grid |
| Stage 1 | |
| Deconstruction | |
| Deconstructed with | Hand Drill |
| Item received | Kit (Sleeper) |
Description
A Sleeper stops the hunger timer while inside. Once properly setup and maintained, allows for controlled sleep giving a safe place to log off. No surrounding atmosphere needed to operate, can go in with full suit and open visor to use.
Basic Setup Example
- Build the Filtration, put in oxygen filter so it throws out the rest
- On the output build a Gas Tank Storage or similar.
- And a Pressure Regulator to feed a constant pressure to the sleeper (27-100kpa).
- Passive Vent or similar to eject the co2 from the waste output.
- Wire it up.
- put your suit airtank in the system (will use 4000kpa from it to charge the pipes).
- Then turn on and jump in for a good nights rest.
This design works because the sleeper connector is bidirectional, and it needs a constant trickle of air flowing to draw out the co2 and clean it up.
Once you build larger systems you might want to feed the air at a proper temperature too, but fresh spawned characters have 20c oxygen tanks.
Advanced Setup Example
This setup is fully autonomous and will take care of maintaining temperature, pressure as well filtering.
- Pressure Regulator is set to desired pressure (100kPa)
- It is important to place AC and Filtration in the specified order
- Oxygen Tank could be any source of oxygen Build the Filtration, put in oxygen filter so it throws out the rest
- Set AC temp to something suitable (20°C)
- Build Heat sink similar to Guide (Air Conditioning), use any suitable coolant, but make sure to have at least 100kPa in heat sink pipe.