Fuel

There are two types of fuel, solid fuel and gas mixtures. The only solid fuel available in the game right now is Coal, coal can be used to fuel the Solid Fuel Generator. In order to use gasses for fuel you need a combustible gas combined with an oxygen source. The only flammable gas in the game is Volatiles (labeled as H₂), the two oxygen sources are Oxygen (2:1 mix simply called fuel) and Nitrous Oxide (1:1 mix called superfuel).

Using Fuels

Fuel Combustion

Autoignition Temperature: 300℃
2 Volatiles + 1 O₂ -> 3 Pollutant + 6 CO₂ + 572kJ

Fuel Combustion Using a H2 Combustor

2 Volatiles + 1 O₂ -> 2 H₂O + 429kJ

Superfuel Combustion

Autoignition Temperature: 50℃
1 Volatiles + 1 N₂O -> 2 N₂ + 2 CO₂ + 572kJ

Note that staying below autoignition temperature means condensation for Nitrous Oxide at more than about 1MPa pressure, making it hard to store the fuel mix in large quantities without liquid management. While this reaction releases the same amount of energy as the classic fuel combustion above, it does so using half the volatiles and heating waste gases with less thermal mass resulting in higher temperatures.

Mixing Fuel

You can easily mix fuel by adding O2 and H2 to a pipe network in order to put it into canisters or pump into a furnace.

H2 can be attained by melting the Ice (Volatiles) that can be found in some worlds while being part of the atmosphere of Vulcan. O2 can be attained by melting the Ice (Oxite) or again from some atmospheres. N₂O is part of Ice (Nitrice) or can be created by the Nitrolyzer.

Depending on how exact the proportions of your gas mixture are you will end up with different end temperatures and pressures after ignition.

Basic Canister Mixing Setup

Parts required

• 2 x Portables Connector
• 2 x Portable Gas Tank
• 1 x Pipe Gas Mixer
• 1 x Gas Tank Storage
• n x Pipes
• n x Cables
• n x Gas Canister

Setup

1. Place both Portable Connectors
2. Connect both Portable Connectors to the the inputs of the Pipe Gas Mixer
3. Connect the Pipe Gas Mixer output to the Gas Tank Storage input
4. Connect the Pipe Gas Mixer power input to power source.

Use

1. Put first Portable Gas Tank or scrubber filled with O₂ on one Portables Connector.
2. Put second Portable Gas Tank or scrubber filled with H₂/volatile on the other Portables Connector.
3. Use a wrench to connect both Portable Gas Tanks to their places.
4. Optional: for a perfect fuel mix, ensure the temperatures of both gases are exactly the same.
5. Set the Pipe Gas Mixer to desired combination (34% O₂ + 66% H₂) Note: as the combination is a floating point number, you can also enter 0.333... or 0.666... with a labeler to get a more precise mix.
6. Turn on Pipe Gas Mixer
7. Place an empty Gas Canister in Gas Tank Storage.

Gases and Liquids
Elements	Compounds	Mixtures	Other
		Fuel (66.6% H2 + 33.3% O2) Air (75% N2 + 25% O2)	Atmosphere Coolant