Difference between revisions of "Pressure Regulator"
From Unofficial Stationeers Wiki
(→Description) |
(Added note about ability of outlet pressure to exceed inlet) |
||
| Line 22: | Line 22: | ||
==Description== | ==Description== | ||
The standard Pressure Regulator will pass through gases until the pressure on its output side reaches the set value. | The standard Pressure Regulator will pass through gases until the pressure on its output side reaches the set value. | ||
| + | The pressure regulator will allow you to set and reach higher outlet pressure than inlet pressure, unlike real life. In this way, this device is acting like a pump or compressor. | ||
=Back Pressure Regulator= | =Back Pressure Regulator= | ||
==Description== | ==Description== | ||
The Back Pressure Regulator will only pass through gases once the pressure on its intake side exceeds the set value. (Not good as emergency dump very slow flow rate.) | The Back Pressure Regulator will only pass through gases once the pressure on its intake side exceeds the set value. (Not good as emergency dump very slow flow rate.) | ||
Revision as of 21:05, 3 April 2018
 | |
| Properties | |
|---|---|
| Stacks | Yes, 5x |
| Recipe | |
| Created With | Hydraulic Pipe Bender, Fabricator |
| Cost | 5g Iron, 1g Gold, 2g Copper |
Contents
Construction Kit (Pressure Regulator)
Description
Pressure Regulator is used throughout Atmospherics networks to manage Pressure. Pressure Regulators comes in two variants: Standard and back-pressure regulators. They can be used to separate two gas networks and as a one-way valve (in any variant, when set to zero).
The maximum pressure that can be set is 10132.5 kPa, which is the maximum pressure for most gas-related elements like Canisters.
Pressure regulator needs power to operate (100 W). When unpowered it shuts off. That means it can be used as Pipe Digital Valve
Use
Use left-click while in active hands to place. Scroll to change to other variants.
Pressure Regulator
Description
The standard Pressure Regulator will pass through gases until the pressure on its output side reaches the set value. The pressure regulator will allow you to set and reach higher outlet pressure than inlet pressure, unlike real life. In this way, this device is acting like a pump or compressor.
Back Pressure Regulator
Description
The Back Pressure Regulator will only pass through gases once the pressure on its intake side exceeds the set value. (Not good as emergency dump very slow flow rate.)