Unofficial Stationeers Wiki Unofficial Stationeers Wiki

Wall Cooler

Properties
Stacks	Yes (5)
Recipe
Created With	Hydraulic Pipe Bender, Fabricator
Cost	3g Iron, 1g Gold, 3g Copper

Wall Cooler

Operation
Power Usage	10W idle + 1000W active
Construction
Placed with	Wall Cooler (Item)
Placed on	Small Grid, On Frames
Stage 1
Deconstruction
Deconstructed with	Hand Drill
Item received	Wall Cooler (Item)

Description

Used to lower the temperature inside a room. It will flash an error if certain things are not present like:

• Coolant gas pipe
• Atmosphere in the room you're trying to cool (minimum is around 5-8kpa, not sure exactly, will flash an error if too low)
• Gasses in the coolant pipe (At least 12.5 kpa)

Game update 0.2.1783.8193 Changed the wall cooler where the efficiency drops as the temperature difference becomes too large. If the waste network becomes 100 degrees warmer than input, efficiency begins to drop until zero at 200 degrees. This is highlighted on the graph on the right.

Efficiency drop off

Usage

Place the Wall Cooler and run some pipes to the place you want to store or vent the heat. Fill the coolant pipe with enough gas and start the machine, it will slowly lower the rooms temperature by transfering its heat to the coolant pipe.

• The wall cooler works by removing 1000 Joules of energy/tick (2000J/s) from the atmosphere and adding it into its pipe.

Data Network Properties

These are all Data Network properties of this device.

Data Parameters

These are all parameters that can be written with a Logic Writer, Batch Writer, or Integrated Circuit (IC10).

Parameter Name	Data Type	Description
Lock
Setting	Boolean	Unused
On

Data Outputs

These are all parameters, that can be read with a Logic Reader or a Slot Reader. The outputs are listed in the order a Logic Reader's "VAR" setting cycles through them.

Output Name	Data Type	Description
Power
Error
Lock
Setting
Maximum
Ratio
On
Required Power