Difference between revisions of "Pipe Gas Mixer"
From Unofficial Stationeers Wiki
(Adding data network infos) |
m (added input 1 and 2 description) |
||
| Line 12: | Line 12: | ||
== Description == <!--T:2--> | == Description == <!--T:2--> | ||
Used to mix two gasses in proportions ranging from 0-100%. A must have for the [[Furnace]] | Used to mix two gasses in proportions ranging from 0-100%. A must have for the [[Furnace]] | ||
| + | Input 1 is the straight thorough route, and Input 2 is the side entry. | ||
{{Data Network Header}} | {{Data Network Header}} | ||
Revision as of 07:36, 2 June 2019
 | |
| Stacks | No |
|---|---|
| Recipe | |
| Created With | Hydraulic Pipe Bender, Fabricator |
| Cost | 2g Iron, 2g Gold, 2g Copper |
Description
Used to mix two gasses in proportions ranging from 0-100%. A must have for the Furnace Input 1 is the straight thorough route, and Input 2 is the side entry.
Data Network Properties
These are all Data Network properties of this device.
Data Parameters
These are all parameters, that can be written to with a Logic Writer, Batch Writer, or Integrated Circuit (IC10). The outputs are listed in the order a Logic Writer's "VAR" setting cycles through them.
| Parameter Name | Data Type | Description |
|---|---|---|
| Lock | Boolean | |
| Setting | float | Correspond to the percentage value of the Input 1 |
| On | Boolean |
Data Outputs
These are all parameters, that can be read with a Logic Reader or a Slot Reader. The outputs are listed in the order a Logic Reader's "VAR" setting cycles through them.
| Output Name | Data Type | Description |
|---|---|---|
| Power | Boolean | |
| Error | Boolean | |
| Lock | Boolean | |
| Setting | float | Contains the current Input 1 value in percent (60.5 for example) |
| Maximum | float | Value of 100 |
| Ratio | Float | Contains the ratio corresponding to the Input 1 value (0.605, for the 60.5 value above) |
| On | Boolean | |
| Requiredpower | Integer | In Watts. The Gas Mixer require 100W of power to function |