Difference between revisions of "Guide (Airlock)"
From Unofficial Stationeers Wiki
(It is possible to "reset" the airlock circuit board using a screwdriver.) |
(→Variants) |
||
| Line 20: | Line 20: | ||
Whichever route you take, it is good practice to put an Area Power Controller inside the airlock to allow a user to power it using batteries should a stations power grid fail. | Whichever route you take, it is good practice to put an Area Power Controller inside the airlock to allow a user to power it using batteries should a stations power grid fail. | ||
| − | If you want to relocate, modify or remove an existing airlock setup, make sure to first disable all the device references set up in the console's Circuitboard using the Data Disk. This will ensure | + | If you want to relocate, modify or remove an existing airlock setup, make sure to first disable all the device references set up in the console's Circuitboard using the Data Disk. This will ensure that doors and vents will be unlocked properly for manual operation before being dismantled or uninstalled. |
| − | You can use a screwdriver to reset the Circuitboard. Drop the board on the ground and hover over it with the screwdriver, then hold left mouse button to reset. | + | You can then use a screwdriver to reset the Circuitboard which will delete all device references stored on the board. Drop the board on the ground and hover over it with the screwdriver, then hold left mouse button to reset it. |
==See Also== | ==See Also== | ||
Revision as of 21:29, 14 January 2026
Description
An airlock is a chamber that can evacuate, modify, or fill its internal volume with differing atmospheres and has two or more airtight portals which all do not open simultaneously. Thus, an airlock allows passage between two or more environments without the exchange of gases or pressures between the connected atmospheres.
Variants
Airlock applications include:
| Guide Variants | Defining Component | Characteristics |
|---|---|---|
| Atmosphere to Atmosphere | 1 x Circuitboard (Advanced Airlock) | Traverse between two environment with differing atmospheres |
| Atmosphere to Vacuum | 1 x Circuitboard (Airlock) | Traverse between a (near) vacuum environment and a pressurized environment |
| Docking Ports | 1 x Kit (Mothership) | Traverse between a stationary base and a Mothership, or between Motherships |
Whichever route you take, it is good practice to put an Area Power Controller inside the airlock to allow a user to power it using batteries should a stations power grid fail.
If you want to relocate, modify or remove an existing airlock setup, make sure to first disable all the device references set up in the console's Circuitboard using the Data Disk. This will ensure that doors and vents will be unlocked properly for manual operation before being dismantled or uninstalled.
You can then use a screwdriver to reset the Circuitboard which will delete all device references stored on the board. Drop the board on the ground and hover over it with the screwdriver, then hold left mouse button to reset it.