Difference between revisions of "Pipe Gas Mixer"
From Unofficial Stationeers Wiki
(updating description warning) |
m (Removed pointless description "behaves Oddly") |
||
| Line 13: | Line 13: | ||
Used to mix two gasses in proportions ranging from 0-100%. A must have for the [[Furnace]]. Input 1 is the straight thorough route, and Input 2 is the side entry. | Used to mix two gasses in proportions ranging from 0-100%. A must have for the [[Furnace]]. Input 1 is the straight thorough route, and Input 2 is the side entry. | ||
| − | |||
{{Data Network Header}} | {{Data Network Header}} | ||
Revision as of 01:23, 17 August 2020
 | |
| Properties | |
|---|---|
| Stacks | No |
| Recipe | |
| Created With | Hydraulic Pipe Bender, Fabricator |
| Cost | 2g Iron, 2g Gold, 2g Copper |
Description
Used to mix two gasses in proportions ranging from 0-100%. A must have for the Furnace. Input 1 is the straight thorough route, and Input 2 is the side entry.
Data Network Properties
These are all Data Network properties of this device.
Data Parameters
These are all parameters that can be written with a Logic Writer, Batch Writer, or Integrated Circuit (IC10).
| Parameter Name | Data Type | Description |
|---|---|---|
| Lock | Boolean | |
| Setting | float | Correspond to the percentage value of the Input 1 |
| On | Boolean |
Data Outputs
These are all parameters, that can be read with a Logic Reader or a Slot Reader. The outputs are listed in the order a Logic Reader's "VAR" setting cycles through them.
| Output Name | Data Type | Description |
|---|---|---|
| Power | Boolean | |
| Error | Boolean | |
| Lock | Boolean | |
| Setting | float | Contains the current Input 1 value in percent (60.5 for example) |
| Maximum | float | Value of 100 |
| Ratio | Float | Contains the ratio corresponding to the Input 1 value (0.605, for the 60.5 value above) |
| On | Boolean | |
| Requiredpower | Integer | In Watts. The Gas Mixer require 100W of power to function |