Difference between revisions of "Circuitboard (Power Control)"
From Unofficial Stationeers Wiki
m |
m (Reorganized sections.) |
||
| Line 12: | Line 12: | ||
== Description == <!--T:2--> | == Description == <!--T:2--> | ||
[[Circuitboard (Power Control)]] can be placed inside of a [[Console]] to form a Power Control Console. It is one of many [[Circuitboard|Circuitboards]] that can be fitted to a Console. | [[Circuitboard (Power Control)]] can be placed inside of a [[Console]] to form a Power Control Console. It is one of many [[Circuitboard|Circuitboards]] that can be fitted to a Console. | ||
| + | |||
| + | == Power Control == <!--T:3--> | ||
| + | The power control console allows the remote operation, i.e. turning on and off, of devices. | ||
<!--T:3--> | <!--T:3--> | ||
| Line 21: | Line 24: | ||
}} | }} | ||
| − | == | + | == Setup == <!--T:4--> |
| − | + | Setup mode can be entered by placing a [[Data Disk]] into the slot on the [[Console]]. | |
| + | When in setup mode, all objects with data access available to the console are listed. | ||
| + | When the console leaves setup mode, devices which had been selected are toggled. | ||
<!--T:4--> | <!--T:4--> | ||
| Line 32: | Line 37: | ||
}} | }} | ||
| − | == | + | == Manual Operation == <!--T:5--> |
| − | + | The setup mode also allows for enabling/disabling manual operation of the selected devices. If this is chosen, then the configured devices which normally have their own toggle available become visibly disabled. | |
| − | |||
| − | |||
<!--T:5--> | <!--T:5--> | ||
| Line 44: | Line 47: | ||
| placed_on_grid = Small Grid | | placed_on_grid = Small Grid | ||
}} | }} | ||
| − | |||
| − | |||
| − | |||
== Mode == <!--T:6--> | == Mode == <!--T:6--> | ||
Revision as of 13:04, 17 November 2018
| Properties | |
|---|---|
| Stacks | no |
| Recipe | |
| Created With | Electronics Printer, Fabricator |
| Cost | 5g Copper, 5g Gold |
Description
Circuitboard (Power Control) can be placed inside of a Console to form a Power Control Console. It is one of many Circuitboards that can be fitted to a Console.
Power Control
The power control console allows the remote operation, i.e. turning on and off, of devices.
| Construction | |
|---|---|
| Placed with | Kit (Consoles) |
| Placed on | Small Grid |
Setup
Setup mode can be entered by placing a Data Disk into the slot on the Console. When in setup mode, all objects with data access available to the console are listed. When the console leaves setup mode, devices which had been selected are toggled.
| Construction | |
|---|---|
| Placed with | Kit (Consoles) |
| Placed on | Small Grid |
Manual Operation
The setup mode also allows for enabling/disabling manual operation of the selected devices. If this is chosen, then the configured devices which normally have their own toggle available become visibly disabled.
| Construction | |
|---|---|
| Placed with | Kit (Consoles) |
| Placed on | Small Grid |
Mode
The setup mode also allows for choosing between Link mode and Toggle mode. In Link mode, all selected devices will be turned either on or off depending on the current setting. In Toggle mode, selected devices will be toggled from their current state to the alternate state, allowing for different devices to be in different states at the same time.