Difference between revisions of "Circuitboard (Power Control)"
From Unofficial Stationeers Wiki
(Created using another circuitboard as a template.) |
m |
||
| Line 49: | Line 49: | ||
== Mode == <!--T:6--> | == Mode == <!--T:6--> | ||
| − | The setup mode also allows for choosing between Link mode and Toggle | + | The setup mode also allows for choosing between '''Link''' mode and '''Toggle''' mode. In '''Link''' mode, all selected devices will be turned either on or off depending on the current setting. |
| − | In Toggle mode, selected devices will be toggled from their current state to the alternate state, allowing for different devices to be in different states at the same time. | + | In '''Toggle''' mode, selected devices will be toggled from their current state to the alternate state, allowing for different devices to be in different states at the same time. |
</translate> | </translate> | ||
Revision as of 13:00, 17 November 2018
| Properties | |
|---|---|
| Stacks | no |
| Recipe | |
| Created With | Electronics Printer, Fabricator |
| Cost | 5g Copper, 5g Gold |
Description
Circuitboard (Power Control) can be placed inside of a Console to form a Power Control Console. It is one of many Circuitboards that can be fitted to a Console.
| Construction | |
|---|---|
| Placed with | Kit (Consoles) |
| Placed on | Small Grid |
Power Control
The power control console allows the remote operation, i.e. turning on and off, of devices.
| Construction | |
|---|---|
| Placed with | Kit (Consoles) |
| Placed on | Small Grid |
Setup
Setup mode can be entered by placing a Data Disk into the slot on the Console. When in setup mode, all objects with data access available to the console are listed. When the console leaves setup mode, devices which had been selected are toggled.
| Construction | |
|---|---|
| Placed with | Kit (Consoles) |
| Placed on | Small Grid |
Manual Operation
The setup mode also allows for enabling/disabling manual operation of the selected devices. If this is chosen, then the configured devices which normally have their own toggle available become visibly disabled.
Mode
The setup mode also allows for choosing between Link mode and Toggle mode. In Link mode, all selected devices will be turned either on or off depending on the current setting. In Toggle mode, selected devices will be toggled from their current state to the alternate state, allowing for different devices to be in different states at the same time.