Difference between revisions of "Pipe Volume Pump"
From Unofficial Stationeers Wiki
(update formula to match more recent mechanics) |
|||
| Line 16: | Line 16: | ||
Used to pump gasses throughout a pipe, featuring an adjustable valve 0-100 Liters and requiring power (2W per Liter). All the gasses in the pipes behind it will be completely pushed in front of it when powered, and blocks any flow of gasses in either direction when unpowered. | Used to pump gasses throughout a pipe, featuring an adjustable valve 0-100 Liters and requiring power (2W per Liter). All the gasses in the pipes behind it will be completely pushed in front of it when powered, and blocks any flow of gasses in either direction when unpowered. | ||
| − | Note that valve settings are for the rate at which the pump operates, in | + | Note that valve settings are for the rate at which the pump operates, in volume per tick (0.5 seconds). |
| − | + | To calculate the moles per tick, use the following equation: | |
n = (P * V) / (R * T) | n = (P * V) / (R * T) | ||
| Line 26: | Line 26: | ||
* n = Moles per tick | * n = Moles per tick | ||
* R = Gas constant (8.3144) | * R = Gas constant (8.3144) | ||
| − | * T = Input temperature | + | * T = Input temperature |
{{Data Network Header}} | {{Data Network Header}} | ||
Revision as of 22:26, 10 December 2021
 | |
| Properties | |
|---|---|
| Stacks | Yes (5) |
| Recipe | |
| Created With | Hydraulic Pipe Bender, Fabricator |
| Cost | 5g Iron, 2g Gold, 3g Copper |
Description
Used to pump gasses throughout a pipe, featuring an adjustable valve 0-100 Liters and requiring power (2W per Liter). All the gasses in the pipes behind it will be completely pushed in front of it when powered, and blocks any flow of gasses in either direction when unpowered.
Note that valve settings are for the rate at which the pump operates, in volume per tick (0.5 seconds).
To calculate the moles per tick, use the following equation: n = (P * V) / (R * T)
Where:
- P = Input pressure
- V = The volume you set
- n = Moles per tick
- R = Gas constant (8.3144)
- T = Input temperature
Data Network Properties
These are all Data Network properties of this device.
Data Parameters
These are all parameters that can be written with a Logic Writer, Batch Writer, or Integrated Circuit (IC10).
| Parameter Name | Data Type | Description |
|---|---|---|
| Lock | Boolean | |
| Setting | Integer | Sets the flow rate between 0 - 100 Liters |
| On | Boolean |
Data Outputs
These are all parameters, that can be read with a Logic Reader or a Slot Reader. The outputs are listed in the order a Logic Reader's "VAR" setting cycles through them.
| Output Name | Data Type | Description |
|---|---|---|
| Maximum | ||
| Lock | Boolean | |
| Error | ||
| Setting | ||
| RequiredPower | ||
| Ratio | ||
| PrefabHash | ||
| Power | ||
| On |