Editing Portable Air Conditioner
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
| Latest revision | Your text | ||
| Line 16: | Line 16: | ||
** Cold mode will flash an error if the temperature is less than -10C (263.15K) | ** Cold mode will flash an error if the temperature is less than -10C (263.15K) | ||
| β | *When set on '''Cold''', it will draw heat from the | + | *When set on '''Cold''', it will draw heat from the atmosphere and store it inside its tank, where the temperature will increase very fast and too high values, which is not an issue, but it will reach it's maximum 8106kPa rather fast and flash an error. It's preferable to attach it to a [[Tank Connector]] and add some pipes with [[Pipe Radiator]]s for longer term cooling. |
*When set on '''Hot''', it will draw heat from its tank and add it into the atmosphere. When the internal heat is depleted no error will be shown and the unit will no longer heat but it will continue to run. To overcome this it needs to be attached to a [[Tank Connector]] to use the hot gases inside a pipe network to heat up the atmosphere, while also cooling the gasses inside the pipe. | *When set on '''Hot''', it will draw heat from its tank and add it into the atmosphere. When the internal heat is depleted no error will be shown and the unit will no longer heat but it will continue to run. To overcome this it needs to be attached to a [[Tank Connector]] to use the hot gases inside a pipe network to heat up the atmosphere, while also cooling the gasses inside the pipe. | ||