Editing Advanced Furnace
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 23: | Line 23: | ||
The Maximum pressure for the furnace is 60 MPa before the furnace will,in short order, explode. | The Maximum pressure for the furnace is 60 MPa before the furnace will,in short order, explode. | ||
Adding Hydrocarbons, IE coal, will increase the pressure. | Adding Hydrocarbons, IE coal, will increase the pressure. | ||
− | Contains two embedded [[Special:MyLanguage/Pipe Volume Pump|volume pumps]] to control flow in and out, in order to use them, the furnace must be powered, and setting both to zero will put the furnace in a state of quiescence, but the furnace will slowly lose pressure and temperature. The capacity of the furnace is in excess of 5kg of materials so | + | Contains two embedded [[Special:MyLanguage/Pipe Volume Pump|volume pumps]] to control flow in and out, in order to use them, the furnace must be powered, and setting both to zero will put the furnace in a state of quiescence, but the furnace will slowly lose pressure and temperature. The capacity of the furnace is in excess of 5kg of materials so using the full 500g ingots to make an alloys is possible. |
== Recipes == | == Recipes == | ||
{{:Advanced Furnace/Recipes}} | {{:Advanced Furnace/Recipes}} | ||
− | |||
− | |||
− | |||
</translate> | </translate> | ||
Line 85: | Line 82: | ||
| [[RecipeHash]] || Integer || Reads recipehash of selected recipe. Can be output to Hash Reader Monitor. <small>Number is calculated using hash on prefabname</small> | | [[RecipeHash]] || Integer || Reads recipehash of selected recipe. Can be output to Hash Reader Monitor. <small>Number is calculated using hash on prefabname</small> | ||
|- | |- | ||
− | | Reagents || Float || Returns the amount of reagents (smeltable ores, not counting ice) in the Furnace, in grams | + | | Reagents || Float || Returns the amount of reagents (smeltable ores, not counting ice) in the Furnace, in grams. |
|- | |- | ||
| RatioWater || Float || Returns a range from 0.0 to 1.0. Returns the percentage ratio of the amount of water in the Furnace. | | RatioWater || Float || Returns a range from 0.0 to 1.0. Returns the percentage ratio of the amount of water in the Furnace. | ||
Line 113: | Line 110: | ||
| On || Boolean || | | On || Boolean || | ||
|- | |- | ||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
|} | |} | ||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
== Usage == | == Usage == | ||
Line 157: | Line 125: | ||
== hot and cold mixing == | == hot and cold mixing == | ||
− | This setup involves a hot tank and a cold tank of gasses, which are then mixed to achieve a target temperature and pumped in to achieve the target pressure. On most worlds maintaining a cold tank is quite easy (because the atmosphere on most worlds is below the temperature needed to smelt ore). Maintaining a hot tank is a little trickier, and either involves a lot of energy spent on [[Pipe Heater]]s, or an auxiliary furnace to combust fuel and pipe the exhaust into an insulated tank. | + | This setup involves a hot tank and a cold tank of gasses, which are then mixed to achieve a target temperature and pumped in to achieve the target pressure. On most worlds maintaining a cold tank is quite easy (because the atmosphere on most worlds is below the temperature needed to smelt ore). Maintaining a hot tank is a little trickier, and either involves a lot of energy spent on [[Pipe Heater]]s, or an auxiliary furnace to combust fuel and pipe the exhaust into an insulated tank. |