Unofficial Stationeers Wiki Unofficial Stationeers Wiki

NOT Gate

A NOT gate, sometimes also called inverter, is a circuit that outputs the value that was not input. It has a single input and output, and each can only take one of two pre-defined values (typically 0 and 1). Whatever the input value is selected, the output value will be the other of the two.

Definition

value table

input	output
0	1
1	0

Connectors

• Input: one of two values (0 or 1)
• Output: the other of the two values

Implementation

NOT gates can often be avoided by modifying the circuit. For instance, an OR Gate with two NOT gates connected to its inputs and outputs can always be replaced by an AND gate with just one NOT gate connected.

Unfortunately, there is no single-component implementation of a NOT gate. However, if you happen to have a data signal with a known value (like a memory containing a constant), often you can feed this signal into a single component in order to turn it into a NOT gate.

Using A Less-Than Comparator

If you have a circuit available (e.g. a constant memory) that has a value b known to stay between 0 and 1 (but not 0), you can turn a Compare Unit into a logic NOT gate by comparing the input x to b, i.e.

not_x = (x < b)

circuit setup

unit	unit type	connector/setting	source / value
compare 1	Compare Unit	Input 1	x (input)
		Input 2	b (constant or bounded value)
		Operation Selector	Lesser
		Output	y (output)

Using An Equality Comparator

If you have a circuit output available that is known to be zero when the NOT gate is used (e.g. a constant memory), you can turn a Compare Unit into a logic NOT gate by comparing the input x to 0, i.e.

not_x = (x = 0)

circuit setup

unit	unit type	connector/setting	source / value
compare 1	Compare Unit	Input 1	x (input)
		Input 2	0 (constant)
		Operation Selector	Equals
		Output	y (output)