Logic Monostable Multivibrator
From Unofficial Stationeers Wiki
Revision as of 22:07, 5 January 2018 by Grilled salmon (talk | contribs) (Created page with "Category:Tutorials <languages /> <translate> = Pulse Former using Logic Gates = '''Author(s):''' illiux#5291, grilled_salmon#1537<br> '''Stationeers Version:''' 0.1.1094.5...")
Revision as of 22:07, 5 January 2018 by Grilled salmon (talk | contribs) (Created page with "Category:Tutorials <languages /> <translate> = Pulse Former using Logic Gates = '''Author(s):''' illiux#5291, grilled_salmon#1537<br> '''Stationeers Version:''' 0.1.1094.5...")
Pulse Former using Logic Gates
Author(s): illiux#5291, grilled_salmon#1537
Stationeers Version: 0.1.1094.5526
Number of Components: 8
This circuit provides a way to extend an input pulse by a set amount of ticks. "Button (Trigger)" will set the math unit to a set tick value when pressed, and the "Math (A + B)" will decrement itself until it is less than zero. The "Compare (Math > 0)" is used as both the output and the control for the "Math (A + B)" to prevent it from counting down forever. NOTE: the input signal must be a pulse. Holding the signal will hold the output as well, regardless of tick setting. Adding edge-triggering between the input and the select will work if you need an edge triggered device.
Design
- 2 Kit (Logic Processor) (Variant: Logic Select)
- 1 Kit (Logic Processor) (Variant: Logic Compare)
- 1 Kit (Logic Processor) (Variant: Logic Math)
- 3 Kit (Logic Memory)
- 1 Kit (Switch) (Variant: Button)
Notes
- Can extend an input pulse by a set amount of ticks (half-seconds), stored in "Memory (OnTicks)." Receiving another pulse during the countdown phase will reset the output signal timer.