Unofficial Stationeers Wiki Unofficial Stationeers Wiki

RS-latch

An RS-latch is a circuit that stores which of its inputs was last "on". It has typically two inputs: input reset storing value "0" and input set storing value "1", hence the name. It can have multiple outputs (possibly inverted), which typically differ mostly in their behavior when multiple inputs are "on" at the same time. Usually, it is considered illegal to set more than one input to "on", but sometimes this is used deliberately (e.g. when constructing an Edge-Triggered RS-Latch).

value table

inputs				outputs
reset	set	output1 (previous)	output2 (previous)	output1	output2
0	0	x	y	y	x
0	1	x	y	0	0
1	0	x	y	1	1
1	1	x	y	0	1

It is possible to define a variant with more than two values. Also, the values stored need not necessarily be 0 and 1.

Connectors

• Enabled: if 1, store data, else do nothing.
• Data: input
• Output: stored value

Using Logic Select Units

An RS-Latch implemented using two Logic Select Units and two Logic Memory units

This RS-latch can store arbitrary values. It can also easily be extended to support more than two different values. It consists of a loop of Logic Select Units, each connected to a dedicated memory cell (or other data source). If all inputs are off, the values circulate in the loop. If one input is on, its corresponding value is read from the respective memory cell and replaces all values in the loop (unless an additional input is on).

Circuit setup

Unit name	Unit type	Connector / Setting	Source / Value
select 1	Logic Select Unit	select	reset (input)
		0 (input 1)	select 2
		1 (input 2)	"0" (constant)
		output	output1 (output)
select 2	Logic Select Unit	select	set (input)
		0 (input 1)	select 1
		1 (input 2)	"1" (constant)
		output	output2 (output)