Unofficial Stationeers Wiki Unofficial Stationeers Wiki

Filtration

Operation
Power Usage	5w
Construction
Placed with	Kit (Atmospherics)
Placed on	Small Grid
Stage 1
Deconstruction
Deconstructed with	Hand Drill
Item received	Kit (Atmospherics)

Purpose

A Filtration unit is a powered Atmospheric processor used to filter specific gases from a mixture. Guide (Filtration) provides additional information regarding the function, construction, and operation of a Filtration unit.

Characteristics

• It has a manual power switch.
• It consumes 10W of Power per Tick when idle and 44W when active.
• It has a separate Power Port and Data Port.
• It has a pipe port (labelled "Input") for the gas mixture from which the designated gas(es) will be filtered.
• It has a pipe port (labelled "Filtered") for the designated gas(es) that have been filtered.
• It has a pipe port (labelled "Unfiltered") for any remaining unfiltered gases.
• It can filter up to 2 different gases at once by inserting two different filters.

Note: When using an I/O slot reader chip, the filter slots are labeled as slot 1, slot 2 and slot 3(IC), with 1 being the slot closer to the inlet. When using an IC chip, the slots are labeled as slot 0, slot1 and slot 2(IC).

User Interface

A Filtration unit provides the following user interface:

Name	Type	Function
Filter (Right)	Slot 0	Port for a gas filter. If gas of the same type is present in the incoming mixture, it will be redirected out the "Filtered" pipe port.
Filter (Left)	Slot 1	Another Port for a gas filter that functions the same as its twin slot. May contain the same or a different filter.
v	Slot 2	IC10 placed in filtration unit (has 2 Input/Outputs)
On	Switch	Switches Filtration unit between turned on or turned off. (On=1/Off=0)

Data Network Properties

These are all Data Network properties of this device.

Data Parameters

These are all parameters that can be written with a Logic Writer, Batch Writer, or Integrated Circuit (IC10).

Parameter Name	Data Type	Description
On	Boolean	Powers on the Filtration unit on when set to 1. Powers off when set to 0.
Open	Boolean
Setting	Integer
Lock	Boolean
Mode	Boolean	0: idle, 1: Active

Data Outputs

These are all parameters, that can be read with a Logic Reader or a Slot Reader. The outputs are listed in the order a Logic Reader's "VAR" setting cycles through them.

Output Name	Data Type	Description
Power	Boolean	Returns whether the Filtration unit is turned on and receives power. (0 for no, 1 for yes)
Error	Boolean	Returns whether the Filtration unit is flashing an error. (0 for no, 1 for yes)
Lock	Boolean	Returns whether the Filtration unit is locked. (0 for no, 1 for yes)
On	Boolean	Returns whether the Filtration unit is turned on. (0 for no, 1 for yes)
RequiredPower	Integer	Returns the current amount of power in Watts required by the Filtration unit.
Quantity	Integer	Returns the current amount of Filter remaining. Slot 0 (Right), slot 1 (Left).

Slot Outputs

Slot0= Filter Left , Slot1= Filter Right , Slot2= Programmable Chip

Output Name	Data Type	Description
OccupantHash	Integer	Filter cartridge Hash-code (Identifier)
Occupied	Boolean	0/1 filter slot empty/occupied
PrefabHash	Integer
Quantity	Integer	Remaining life of filter cartridge.
Class	Integer
Dammage	Integer
MaxQuantity	Integer	Max. life of filter cartridge

See Also

• Guide (Filtration)

• Kit (Atmospherics)
• Portable Scrubber