Difference between revisions of "Constructing and Deconstructing Walls"
From Unofficial Stationeers Wiki
(Created page with " == Summary == Getting the basic structure for your base is usually the one of the first things you do. You will need a base to install your solar panels, solid fuel generat...") |
m (→Descontructing: Fixed typo in title(deScontructing? lol), cleared information about placing cables(it's unnecessary to clear ALL sheets).) |
||
| Line 36: | Line 36: | ||
That completes one wall/ceiling/floor that you can place structures on. | That completes one wall/ceiling/floor that you can place structures on. | ||
| − | == | + | == Deconstructing == |
| − | The frame is broken down in stages. First you remove the sheets using a [[wrench]] and then the [[Angle Grinder|angle grinder]] to take down the actual frame once | + | The frame is broken down in stages. First you remove the sheets using a [[wrench]] and then the [[Angle Grinder|angle grinder]] to take down the actual frame once all sheets are removed. |
| − | It is often needed to remove | + | It is often needed to remove one layer of [[Iron Sheets]] so you can pass new cables through a wall. In which case on [[wrench]] is needed. |
Revision as of 01:28, 19 December 2017
Summary
Getting the basic structure for your base is usually the one of the first things you do. You will need a base to install your solar panels, solid fuel generator and get the battery charger hooked up to an APC to get power from the solar panels. You need frames to attach these structures too.
What you need
Iron Frames
Iron Frames are your basic building blocks. Iron walls can be used but they don't allow structures to be placed. Iron frames do not have to have iron sheets added on them to place structures. You can use the frame itself. The frame without sheets allows you to walk through it and place cables and pipes inside. Which you can seal up after to pass connections through rooms.
Iron Frames
Placed
One sheet added
Second sheet added completed
Constructing
Grab an Iron Frames in an active hand use right-click to bring up place mode and left-click when frame is in desired spot.
Then place a welder in one hand and Iron Sheets in the other hand, two per frame you wish to install. The welder needs to be the active hand.
Use the 'O' button to toggle the welder on.
Then aim at the frame of the Iron Frames and left click. The welder will go through a green progress bar adding one Iron Frame from the inactive hand.
That completes one wall/ceiling/floor that you can place structures on.
Deconstructing
The frame is broken down in stages. First you remove the sheets using a wrench and then the angle grinder to take down the actual frame once all sheets are removed.
It is often needed to remove one layer of Iron Sheets so you can pass new cables through a wall. In which case on wrench is needed.