Difference between revisions of "Automated Room Light"
From Unofficial Stationeers Wiki
(Created page with "== Definition == This is an automated light system that uses an occupancy sensor to turn lights on and off in a room. == Disclaimer == The room needs to be closed off by a d...") |
(→What you will need) |
||
| Line 9: | Line 9: | ||
*[[Sensors|Kit (Sensors)]] X1 | *[[Sensors|Kit (Sensors)]] X1 | ||
*[[Kit (Logic I/O)]] X2 | *[[Kit (Logic I/O)]] X2 | ||
| − | |||
| − | |||
== Set Up == | == Set Up == | ||
Revision as of 10:48, 28 July 2024
Definition
This is an automated light system that uses an occupancy sensor to turn lights on and off in a room.
Disclaimer
The room needs to be closed off by a door/hatch for the logic to work and all the walls have to be put into place with at least one sheet put into them before this will work.
What you will need
- Kit (Sensors) X1
- Kit (Logic I/O) X2
Set Up
- This is not a must, set up each room with its own Power Controller.
- While holding the Kit (Sensors), scroll till you can place Occupancy Sensor.
- Place your Kit (Logic Memory).
- While holding the Kit (Logic Processor), scroll till you can place Compare Unit.
- While holding the Kit (Logic I/O), scroll till you can place a Logic Writer.
- While holding the Kit (Logic I/O), scroll till you can place a Batch Writer.
- Connect all Cable Coils to all the ports on each of the logic.
Assigning Signals
