Editing Semi-Automatic Autolathe
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
| Latest revision | Your text | ||
| Line 1: | Line 1: | ||
| − | This logic | + | This logic kit will allow your autolathe to build a stack of whichever item you select, up to the quantity specified by your stacker. It will then turn off your autolathe and turn it back on. You can use this and replace the autolathe with any other fabricator such as an electric printer or a hydraulic pipe bender. |
You will need: | You will need: | ||
| − | * | + | * Autolathe |
| − | * | + | * Stacker |
| − | * 4 | + | * 4 Logic I/O chips (2 Logic Writer, 2 Logic Reader) |
| − | * 2 | + | * 2 Logic Processor Chips (Compare) |
* Cable coils to connect all parts | * Cable coils to connect all parts | ||
| Line 15: | Line 15: | ||
[[File:Automate Electric Printer.png|thumb|Automated Electric Printer]] | [[File:Automate Electric Printer.png|thumb|Automated Electric Printer]] | ||
| − | '''Logic Reader A:''' | + | '''Logic Reader A:''' |
| − | In : Stacker | + | In : Stacker |
Var: Setting | Var: Setting | ||
| − | '''Logic Reader B:''' | + | '''Logic Reader B:''' |
| − | In : Autolathe | + | In : Autolathe |
Var: ExportCount | Var: ExportCount | ||
| − | '''Compare Unit C:''' | + | '''Compare Unit C:''' |
| − | In1: A | + | In1: A |
| − | In2: B | + | In2: B |
Out: Greater | Out: Greater | ||
| − | '''Compare Unit D:''' | + | '''Compare Unit D:''' |
| − | In1: A | + | In1: A |
| − | In2: B | + | In2: B |
Out: Equals | Out: Equals | ||
| − | '''Logic Writer:''' | + | '''Logic Writer:''' |
| − | In : C | + | In : C |
| − | Out: Autolathe | + | Out: Autolathe |
Var: On | Var: On | ||
| − | '''Logic Writer:''' | + | '''Logic Writer:''' |
| − | In : D | + | In : D |
| − | Out: Autolathe | + | Out: Autolathe |
Var: ClearMemory | Var: ClearMemory | ||
This circuit works by keeping the autolathe on while it's current ExportCount is less than the setting on the Stacker that you have attached. Once the ExportCount reaches the stacker setting, the autolathe's memory is reset(setting ExportCount to 0) and the Autolathe is powered off for one tick and then powered back on. | This circuit works by keeping the autolathe on while it's current ExportCount is less than the setting on the Stacker that you have attached. Once the ExportCount reaches the stacker setting, the autolathe's memory is reset(setting ExportCount to 0) and the Autolathe is powered off for one tick and then powered back on. | ||