Editing Circuitboard (Door Control)
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
| Latest revision | Your text | ||
| Line 21: | Line 21: | ||
}} | }} | ||
| − | == Door Control == <!--T: | + | == Door Control == <!--T:4--> |
| − | The | + | The door control console allows the remote operation (opening and closing) of doors. |
| − | <!--T: | + | == Setup == <!--T:5--> |
| + | Setup mode can be entered by placing a [[Data Disk]] into the slot on the [[Console]]. | ||
| + | When in setup mode, all objects with data access available to the console are listed, however only doors are available to be selected (highlighted green). | ||
| + | When the console leaves setup mode, doors which had been selected are toggled. | ||
| + | |||
| + | <!--T:6--> | ||
{{Structurebox | {{Structurebox | ||
| name = Console (Door Control) in setup mode | | name = Console (Door Control) in setup mode | ||
| Line 32: | Line 37: | ||
}} | }} | ||
| − | == | + | == Manual Operation == <!--T:7--> |
| − | + | The setup mode also allows for enabling/disabling manual operation of the doors. If this is chosen, then the configured doors which normally have their own toggle available become visibly disabled. | |
| − | |||
| − | |||
| − | <!--T: | + | <!--T:8--> |
{{Structurebox | {{Structurebox | ||
| name = Manual Operation Disabled | | name = Manual Operation Disabled | ||
| Line 44: | Line 47: | ||
| placed_on_grid = Small Grid | | placed_on_grid = Small Grid | ||
}} | }} | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
</translate> | </translate> | ||