Editing Automated Temperature Regulation
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
| Latest revision | Your text | ||
| Line 28: | Line 28: | ||
# Place all 3 [[Kit (Logic Memory)]] units nearby<br>Label these as "Temp Min", "Temp Mid" and "Temp Max" and set your desired temperatures in kelvin | # Place all 3 [[Kit (Logic Memory)]] units nearby<br>Label these as "Temp Min", "Temp Mid" and "Temp Max" and set your desired temperatures in kelvin | ||
# Wire all units together | # Wire all units together | ||
| β | # "Temp Reader" should be set to read "Temperature" from your Gas sensor | + | # "Temp Reader" should be set to read "Temperature" from your Gas sensor |
# Configure your "Cooling Select";<br>Select: "Cooling Compare"<br>Input 1: "Max Temp"<br>Input 2: "Mid Temp" | # Configure your "Cooling Select";<br>Select: "Cooling Compare"<br>Input 1: "Max Temp"<br>Input 2: "Mid Temp" | ||
# Configure your "Cooling Compare";<br>Input 1: "Temp Reader"<br>Mode: Greater<br>Input 2: "Cooling Select" | # Configure your "Cooling Compare";<br>Input 1: "Temp Reader"<br>Mode: Greater<br>Input 2: "Cooling Select" | ||