Editing Automated Temperature Regulation
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
Latest revision | Your text | ||
Line 1: | Line 1: | ||
β | |||
<big>'''Automated temperature regulation using logic chips'''</big><br><br> | <big>'''Automated temperature regulation using logic chips'''</big><br><br> | ||
'''Author:''' Jaffa | '''Author:''' Jaffa | ||
<br><br> | <br><br> | ||
β | This logic will allow you to automatically keep your atmos temperature within a minimum and maximum temperature without annoying clicking. This setup assumes that your [[Wall Cooler|Wall Coolers]] and [[Wall Heater|Wall Heaters]] are on a separate network for the room you want to control the temperature of | + | This logic will allow you to automatically keep your atmos temperature within a minimum and maximum temperature without annoying clicking. This setup assumes that your [[Wall Cooler|Wall Coolers]] and [[Wall Heater|Wall Heaters]] are on a separate network for the room you want to control the temperature of and your atmosphere isn't highly flammable. Network separation can be obtained through a [[Transformer]] or [[Area Power Controller]].<br> |
<br> | <br> | ||
'''Resources needed:'''<br> | '''Resources needed:'''<br> | ||
Line 28: | Line 27: | ||
# Place all 3 [[Kit (Logic Memory)]] units nearby<br>Label these as "Temp Min", "Temp Mid" and "Temp Max" and set your desired temperatures in kelvin | # Place all 3 [[Kit (Logic Memory)]] units nearby<br>Label these as "Temp Min", "Temp Mid" and "Temp Max" and set your desired temperatures in kelvin | ||
# Wire all units together | # Wire all units together | ||
β | # "Temp Reader" should be set to read "Temperature" from your Gas sensor | + | # "Temp Reader" should be set to read "Temperature" from your Gas sensor |
# Configure your "Cooling Select";<br>Select: "Cooling Compare"<br>Input 1: "Max Temp"<br>Input 2: "Mid Temp" | # Configure your "Cooling Select";<br>Select: "Cooling Compare"<br>Input 1: "Max Temp"<br>Input 2: "Mid Temp" | ||
# Configure your "Cooling Compare";<br>Input 1: "Temp Reader"<br>Mode: Greater<br>Input 2: "Cooling Select" | # Configure your "Cooling Compare";<br>Input 1: "Temp Reader"<br>Mode: Greater<br>Input 2: "Cooling Select" |