Difference between revisions of "Semi-Automatic Autolathe"
From Unofficial Stationeers Wiki
(Created page) |
(changed wording about images) |
||
| Line 9: | Line 9: | ||
* Cable coils to connect all parts | * Cable coils to connect all parts | ||
| − | + | Clicking on the image in this article will show you an example of this setup ingame with all screws annotated. | |
[[File:Automate Autolathe Logic.png|thumb|Description of Logic Circuits to Automate Autolathe]] | [[File:Automate Autolathe Logic.png|thumb|Description of Logic Circuits to Automate Autolathe]] | ||
| − | |||
| − | |||
[[File:Automate Electric Printer.png|thumb|Automated Electric Printer]] | [[File:Automate Electric Printer.png|thumb|Automated Electric Printer]] | ||
Revision as of 23:03, 9 September 2019
This logic kit will allow your autolathe to build a stack of whichever item you select, up to the quantity specified by your stacker. It will then turn off your autolathe and turn it back on. You can use this and replace the autolathe with any other fabricator such as an electric printer or a hydraulic pipe bender.
You will need:
- Autolathe
- Stacker
- 4 Logic I/O chips (2 Logic Writer, 2 Logic Reader)
- 2 Logic Processor Chips (Compare)
- Cable coils to connect all parts
Clicking on the image in this article will show you an example of this setup ingame with all screws annotated.
Logic Reader A: In : Stacker Var: Setting
Logic Reader B: In : Autolathe Var: ExportCount
Compare Unit C: In1: A In2: B Out: Greater
Compare Unit D: In1: A In2: B Out: Equals
Logic Writer: In : C Out: Autolathe Var: On
Logic Writer: In : D Out: Autolathe Var: ClearMemory
This circuit works by keeping the autolathe on while it's current ExportCount is less than the setting on the Stacker that you have attached. Once the ExportCount reaches the stacker setting, the autolathe's memory is reset(setting ExportCount to 0) and the Autolathe is powered off for one tick and then powered back on.