Console

Console

Construction
Placed with	{{{placed_with_item}}}
Placed on	{{{placed_on_grid}}}

Information

The console can be equipped with several circuit devices. When putting in a data disk, the console can be configured. After putting out the data disk it runs like previously configured.

Example set up

For example one can set it to pressure measurement (requires gas circuit board inside) which allows one to read out the actual pressure value of a connected gas sensor. (Setup shown in picture)

Tips

• You need to put a sheet of glass on top of it to bring it finally to work.
• It finds all the devices which are connected to your power grid, even if they are not related to the actually installed circuit board. Not related devices are greyed out which allows you to find fast the related devices inside the list.
• Even if it shows just a power input, it also uses the power input as a powerline data input, allowing the console to see all the devices connected to the actual grid. (Maybe some bug or unfinished graphics)

Power Consumption

It requires always 50W of power.

Deconstruction

First remove the glass sheet with a Crowbar. The device itself is deconstructed with the Drill.