Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
| Latest revision |
Your text |
| Line 36: |
Line 36: |
| | 10g [[Rocket]] Automated Rocket Automation Module | | 10g [[Rocket]] Automated Rocket Automation Module |
| | 5g [[Sensor Lenses]] | | 5g [[Sensor Lenses]] |
| | + | </translate> |
| | | | |
| − | == Recipes ==
| |
| − |
| |
| − | Using an [[Advanced Furnace]] on Mars it is possible to smelt Inconel by using a gas mix of
| |
| − | * 50% CO<sub>2</sub>
| |
| − | * 33% H<sub>2</sub> ( = 66% /2 )
| |
| − | * 17% O<sub>2</sub> ( = 34% /2)
| |
| − | * at 291K (18°C)
| |
| − | Pressurize the furnace to over 2100 kPa. After igniting this will give you a pressure of 26800 kPa and temperature of 1900K. As the reagents melt, the temperature will decrease and with it the pressure. Unless the furnace is in a vacuum, it will conduct heat to the surrounding atmosphere and eventually drop to the 24MPa level and you can dispense the ingot. If the furnace ''is'' in a vacuum, you can activate the output pump of the furnace (start at 1L) to bring the pressure down.
| |
| − |
| |
| − | This recipe was tested in creative to create a 25g ingot of inconel from 50g of gold ore, 25g of nickel ore, and 50g of steel ingot. Larger batches will probably require a higher starting pressure to provide enough energy to melt the increased mass.
| |
| − |
| |
| − | These values were calculated using [[Furnace temperature and pressure math]].
| |
| − |
| |
| − | </translate>
| |
| | | | |
| | Update 0.2.2728.13232 - Fri 15/01/2021 | | Update 0.2.2728.13232 - Fri 15/01/2021 |
